I want to make some art out of 12ax7 vacuum tubes. Does anyone know how to wire them just to glow?

Posted by  in Sunday, February 15th 2009   
Topics: Pro Audio    
tubes for amplifier9 I want to make some art out of 12ax7 vacuum tubes. Does anyone know how to wire them just to glow? on Audiograveyard.info
toolongdays asked:


I am a musician but I also dabble in art and I would like to do something creative with vacuum tubes. I want to take 200 or so Ecc83s and build something with them. I have a little electronics know-how but i dont want to get involved to the point where i have to build an amplifier circut around that many tubes. They dont need to actually function, just to glow for the visual effect. If you have any tips or know how to do this write me an email at toolongdays@yahoo.com. Thanks a bunch. Dan

Check Equifax score free
Sphere: Related Content

4 Comments

cdf-rom said in February 17th, 2009 at 5:33 pm    

I sort of wish you wouldn’t do that. Tubes are getting more expensive and harder to find every day. You could probably get a nice bit of change from people who can use them. If it’s just the effects you want, use LED’s with batteries, or little 4 watt nightlight bulbs and run the bulbs at lower than usual power (like through a small step-down transformer) to make them glow just red instead of too bright to look at.

6 NOV 06, 0618 hrs, GMT.

athiestforthebirthofjesus said in February 20th, 2009 at 8:03 am    

put 6.3 vac across the “filament” termianals

I *think* they are numbers 1 and 2 … take a meter
and read resistances between adjacent pins and where
you find a sorta small R-value, you will likely have located
the ‘filament’

the 6.3 vac should come from the secndary of a transformer since it will draw considerable current

(the pins will be teh “first-two” or the “last-two” depending on how you count from the “gap” in the circular arrangenement of pins on the bottom of teh tube

for safety’s sake, put a fuse in the circuit (or a ckt breaker) you figure out the value depending on how many tubes you light up

good luck

Pretzels said in February 23rd, 2009 at 6:58 pm    

In vacuum tubes, the first number is the filament voltage, for a 12AX7 that is 12 volts. I would poke around with an ohmmeter to find what pairs of pins give continuity. Since the filament voltage is the lowest in the tube, you can put the 12 volts about anywhere without damage. The correct pins will light the tube up. It shouldn’t damage teh tube to use it this way.

Trailcook said in February 27th, 2009 at 6:05 am    

I’m with cdf-rom. You’ll get some good dough from selling the tubes.
Also, you will probably be disappointed with your project because the tubes do not glow very brightly but get very hot. Also it will use a lot of electricity.
I recommend you illuminate the tubes with LEDs. They are inexpensive, run forever, and use practically no current.

Related Articles

  1. How can I obtain the owners manual of my Marantz CDR17?
  2. Tube Amplifier questions?
  3. McIntosh + Dynaudio + Clearaudio
  4. Does anyone know anything about the brand Marantz?
  5. Tube amplifier won’t turn on?

Sponsors

Leave Your Comments Below

«
»